Brewer Needle Cleaning Tool/Maintenance Accessory - Compatible With Keurig 2.0

Brewer Needle Cleaning Tool/Maintenance Accessory - Compatible With Keurig 2.0

18.99

NO MORE PARTIAL BREWS OR GROUNDS IN YOUR COFFEE: Are you getting partial / interrupted brews, grounds in your coffee, or a "water under pressure" message? There's a good chance you have a clogged entrance / exit needle caused by a natural build-up of coffee grounds. Our tool removes those grounds and gets your Keurig (R) brewer running smoothly again

  • LENGTHENS THE LIFE OF YOUR MACHINE: Our needle cleaning accessory is a key aspect of your brewer maintenance, along with regular cleaning and descaling. A clogged needle, if left untreated for too long, can lead your machine to break down. Don't let that happen - regularly clean your brewing needle!

  • COMPATIBLE WITH KEURIG (R) 2.0: Compatible with all Keurig (R) 2.0 and Plus Series brewers / coffee makers / coffeemakers, including model #s K200, K250, K300, K350, K375, K400, K450, K460, K475, K500, K550, K560, K575, K600, K650, K660, K675. Will not work with K55 Machine.

  • EASY TO USE: Super simple to use - just a few minutes and you'll be back up and running! Instructions below. NOTE: Will not work with non-Keurig (R) brewers or other Keurig (R) models not listed

  • Please note: This is an aftermarket replacement product (produced by Impresa Products). We have no affiliation with or endorsement from any of the manufacturers mentioned

Quantity:
Add To Cart

INSTRUCTIONS FOR USE: 1) Ensure that your brewer is powered off. 2) Ensure that the silicone chamber is seated in the plastic holder with the entrance facing up. 3) Entirely fill the silicone chamber with warm water. 4) Lift the handle (where you would normally place a pod) and place the cleaning tool in the pod holder. 5) Ensure that the cleaning tool is fully seated and flush with the pod holder. If it is not fitting in, adjust until it fits smoothly. 6) Raise and lower the handle 5 times, each (5 ups and 5 downs). This will flush water through the needle to remove the coffee grounds. 7) Remove the cleaning tool from the pod holder. You will see collected coffee grounds. 8) Perform a cleansing brew, ensuring that there is a mug on the drip tray. NOTE: Ensure that the pod slot is empty during the cleaning brew. Some models may require you to hold down the brew button (to brew 6 ounces of hot water). 9) Once the brew is complete, pour the contents of the mug into the sink. Rinse the cleaning tool with warm water and allow to fully air dry. This is a generic product manufactured and distributed by Impresa Products (TM). This is not a Keurig (R) OEM product and Impresa Products has no affiliation with or endorsement from Keurig (R). Our product is not covered under any Keurig (R) manufacturer's warranty. The Keurig (R) brand names and logos are the registered trademarks of their owners. Any use of the Keurig (R) brand names, models or any other related designations are made solely for purposes of describing and illustrating compatibility.